You are not logged in.

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

jksdoc

Active Member

1

Saturday, September 29th 2007, 2:30pm

presure loss per head

Could someone please explain pressure drop. I understand that if I have 50 psi at the valve, and with 3/4" pvc @5gpm there would be 1.45 psi loss per 100 feet. But say I have 200ft of 3/4pvc with 4 or 5 maxipaws spread, I get the 3psi drop from the pipe, but I dont know how to calculate psi drop from the heads??
Thanks tons

Wet_Boots

Supreme Member

Posts: 4,053

Location: Metro NYC

2

Saturday, September 29th 2007, 3:23pm

Heads use water, at a certain gpm, and the total gpm number is used to calculate pressure losses through pipe and valves.

jksdoc

Active Member

3

Sunday, September 30th 2007, 8:09am

Thanks wetboots, could you please give an example so I can see the big picture? Thanks

Wet_Boots

Supreme Member

Posts: 4,053

Location: Metro NYC

4

Sunday, September 30th 2007, 9:28am

irrigationtutorials.com

HooKooDooKu

Supreme Member

5

Monday, October 1st 2007, 4:07am

It's not a question of pressure drop at the head. It's a question of do you have enough pressure left by the time the water reaches the heads.

Wet Boots has it right, you need to read the materials available at www.irrigationtutorials.com.

But the basic idea is you start with your static water pressure, subtract off all of the expected pressure losses, and the resulting value is the working pressure of the heads. The specifications of the heads will tell you what pressure ranges it can operate at and what it's performance (usually in the way of water radius and gpm) will be a various working pressures.

So usually, one of the ways to work it is to assume an expected working pressure at the heads (say 40psi). You look at the specs of the sprinkler heads and determine what their gpm flow rate is going to be at that pressure. You then use those flow rates to determine your pressure losses in the meter, filter, backflow, valves and pipe. If your static water pressure minus all these calculated pressure losses is less than the assumed 40psi working pressure at the head, then the head will not perform as designed. You will have to find ways to reduce your pressure losses (larger pipe and lower total gpm by using fewer heads per zone).


Rate this thread