You are not logged in.

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Mikeee

Starting Member

Posts: 1

Location: USA

1

Sunday, April 22nd 2007, 9:24am

Repair of FEBCO 765 Backflow valve

<font face="Comic Sans MS"></font id="Comic Sans MS"><font color="navy"></font id="navy">
[:(] I hope that this is the right forum to use for this question ?
Hi All, a few weeks ago my FEBCO 765 Backflow valve/Pressure Vacuum Breaker did an internal self destruct.
We had a mild freeze and it might have frozen, but I have had problems with the poppet for several years now. The 765 casing looks ok.
Anyway, I need to get internal replacement parts (all of them) for the 765.
I measured the incoming water supply line and it was 1.3 inches so am I right in assuming that I have a 1 1/4" model 765 ?

From looking a FEBCO 765 parts breakdown sheet - it looks like these are the parts that I need.
905-212 Bonnet/Poppet Kit
905-052 Check Assembly Kit
630-106 Check Spring

The real question that I have is -- Wouldn't it be cheaper if I just bought a 1" FEBCO and took the parts out of it to rebuild my 765 ?
Are there any plus's or minus's in doing this ? or should I just purchase the rebuild kits listed above ?

[?]
Mikeee
------------------
Mikeee

Wet_Boots

Supreme Member

Posts: 4,060

Location: Metro NYC

2

Sunday, April 22nd 2007, 2:04pm

Figure you have a one inch Febco - inch-and-a-quarter PVBs are rather rare.

jmduke7

Advanced Member

Posts: 158

Location: FT. Walton Beach, Florida

3

Sunday, April 22nd 2007, 2:21pm

With my experience on Febco parts, you could but a second home for the same price as the replacement parts. Febco makes a quality product, but are often priced way off on the repair parts. My suggestion is to just get the parts, or better yet, purchase a Watts PVB (model 800 series 1"). The watts are less expensive and are way cheaper for the replacement parts, especially if this were to happen again.

Beat of Luck
&lt;&gt;&lt;
Josh
Irrigation /Landscape Lighting / Pump and Well Specialist

Rate this thread