You are not logged in.


Starting Member


Sunday, September 25th 2005, 4:06am

Insert barb tips

Any tips on fully inserting 3/4" barbed fittings? Can a lubricant be used to make them slip on easier? The old twist-n-push method is fine when doing new work, but I have a crack in one line and know it will be a struggle to get a straight dual-barbed fitting into place.


Supreme Member

Posts: 5,287

Location: Metro NYC


Sunday, September 25th 2005, 8:39am

Depending on the depth, you either dig up enough pipe to have similar freedom of movement to new work, or else you end up looking for an expanding insert coupling, or two separate pieces you can thread into each other, like an insert x female adapter and an insert x male adapter.


Active Member


Sunday, September 25th 2005, 4:11pm

A flaring tool works good:

You can also use a hair dryer to soften up the poly pipe.

Rate this thread