You are not logged in.

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

NJDIYER

Starting Member

1

Sunday, September 25th 2005, 4:06am

Insert barb tips

Any tips on fully inserting 3/4" barbed fittings? Can a lubricant be used to make them slip on easier? The old twist-n-push method is fine when doing new work, but I have a crack in one line and know it will be a struggle to get a straight dual-barbed fitting into place.

Wet_Boots

Supreme Member

Posts: 4,077

Location: Metro NYC

2

Sunday, September 25th 2005, 8:39am

Depending on the depth, you either dig up enough pipe to have similar freedom of movement to new work, or else you end up looking for an expanding insert coupling, or two separate pieces you can thread into each other, like an insert x female adapter and an insert x male adapter.

tozar

Active Member

3

Sunday, September 25th 2005, 4:11pm

A flaring tool works good:

http://www.sprinklerwarehouse.com/detail.aspx?ID=1677

You can also use a hair dryer to soften up the poly pipe.

Rate this thread