You are not logged in.

NABRIL

Active Member

1

Sunday, December 16th 2012, 5:53pm

Way to better close off a nozzle head

Hello
I know that I can turn the screw clockwise on top of the nozzle in order to close the flow of water, but for some reason I have 2 that still spurt out water despite tightening that screw. I also know that, if I wanted, I could dig around the area, remove the riser, and screw in a threaded pvc cap. If I do that and I want to re-enable that nozzle in say 4 years, I will have no way of locating where that cap is.

Is there some female threaded "cap" that can be screwed into the riser in place of a nozzle?
I guess I could remove the riser, screw in a 4 inch riser pipe and cap it. In 4 years it should be less difficult to locate that white cap. No?

thanks

mrfixit

Moderator

Posts: 2,273

Location: USA

2

Sunday, December 16th 2012, 7:11pm

Since you're talking years down the road. I'd dig it up and put the taller riser on with a cap.
---
If there's not a screen under the nozzle you wont be able to turn it off. If the screen is damaged it might dribble some. A new screen might help.
--
I don't know of a cap to replace the nozzle.

screenless mike

Unregistered

3

Saturday, August 18th 2018, 7:07pm

thanks mr. fixit.

Some five years later you solve my problem. Thanks for the info re: the screen, and it's dual function, both water filter, and, gasket/washer for the screwdown function that stops the water flow..................THANK YOU ! :P

Rate this thread