You are not logged in.

Mike T

Starting Member

1

Thursday, August 9th 2018, 10:06am

Toro Vision 2 with wired rain sensor

Rain sensor became damaged + detached with wire severed.
I don't need the rain sensor to work.
Although the control box seems to be working normally and the lights go through the usual sequence the pump doesn't come on and watering doesn't occur.
I suspect that if the rain sensor circuit was removed/by-passed the system would work OK..........am I right? If so, how do I do it?
Although old, the system worked fine prior to the rain sensor issue.
Thanks,
Mike.

mrfixit

Moderator

Posts: 2,295

Location: USA

2

Thursday, August 9th 2018, 2:48pm

Try turning the sensor switch to off. It's located to the left of the terminals.

mrfixit

Moderator

Posts: 2,295

Location: USA

3

Friday, August 10th 2018, 3:25am

Make sure the common wire is hooked directly to the common terminal after you disconnect it from the rain sensor.

Rate this thread