You are not logged in.

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

ears54

Unregistered

1

Sunday, May 29th 2016, 9:22pm

orbit converter valve leak

replacing old valves with new. Orbit model 57030 1" brass. After installing the new valve into the brass valve body, I have a couple of valves leaking where the two brass parts meet. I have cleaned and leveled the face of the valve body and I do see any issue in the o-ring seat. The instructions do not mention using any grease or sealant for this connection, but I wonder if a bit of valve grease or silicon grease might help.

Thanks

mrfixit

Moderator

Posts: 2,295

Location: USA

2

Sunday, May 29th 2016, 11:33pm

I never install the adapter in question but I do install the Irritrol 300 which usues an O-ring instead of a fiber washer. I've uninstalled a pile of them though.
If you over tighten it the O-ring might leak.
You could try using a 1" fiber washer instead of the O-ring.
Some people put teflon tape on the threads. I don't recommend that but it would probably work.
Are you sure the water's coming from where the adapter seats and not from the cap side of the valve? Did you check the washer on the float and the washer under the cap? I'm just assuming you have ASV's. Maybe you have angle valves.
Can you post a pic of the valve? Go to www.tinypic.com and cut n past the forum code here after you've uploaded your photo.
To answer your question about grease, It might help. One way to find out.

ears54

Unregistered

3

Monday, May 30th 2016, 11:22am

orbit converter valve leak

Mrfixit, thanks for the reply.

I don’t have a pic of the installation but I’ve attached one of the valve itself. The leak is definitely
from where the adapter seats and these valves use o-rings. I will try the grease and possibly the Teflon tape. I had not thought of the fiber washers.


Wet_Boots

Supreme Member

Posts: 5,277

Location: Metro NYC

4

Monday, May 30th 2016, 11:40am

The existing valve body might need a cleaning before you seat the adapter. In any event, teflon tape won't gum up the works, so apply what you need. Since the original Champion valve bodies used a gasket for a seal, the O-ring is a bit of a surprise.

Rate this thread