You are not logged in.

1

Tuesday, May 10th 2016, 4:05pm

Relief Valve issue on one of four zones

Hello, not sure if I'm asking this question in the right spot. I purchased a new house that has a well pump irrigation system with 4 zones. Three of the four zones work fine. The zone closest to the well pump has an issue where when that zone is on, the relief valve at the top of the well line sprays out a lot of water. None of the sprinklers work on this zone when this happens. Is it possible that one of my lines on this zone are cloggedcausing a major pressure build up?

Wet_Boots

Supreme Member

Posts: 5,145

Location: Metro NYC

2

Tuesday, May 10th 2016, 4:30pm

Find the trouble valve and manually open it, then try that zone again.

3

Tuesday, May 10th 2016, 7:43pm

I will give it a try and report back. Thanks!

4

Wednesday, May 11th 2016, 2:07pm

Valve wasn't opening because one of the wires were loose on the controller. Problem fixed! Thanks

Rate this thread