You are not logged in.

Benmt

New Member

1

Friday, July 25th 2014, 8:34pm

Changed controller, now 1 zone not working

I replaced a Imperial controller with a new Orbit controller. 5 of 6 zones are working fine. One zone will not come on. I tried switching the wire to a different terminal, no success. I opened the solenoid and was able to get that zone on. There is no obvious breaks in the wire at either end.

Could the solenoid have been damaged by changing the controller?
Any other ideas? Thanks in advance.

Wet_Boots

Supreme Member

Posts: 4,064

Location: Metro NYC

2

Saturday, July 26th 2014, 6:30am

Probably best to use a multimeter and make resistance measurements of the zone wiring, before you go further.

Rate this thread