You are not logged in.

john058

Starting Member

1

Friday, May 9th 2014, 6:52pm

No water to plants!

My control valve froze and burst during the winter. I replaced the diaphragm and the valve, still no water. I found a leak in the piping and replaced the piping.
Entire system 'seems' to be leak proof. When the valve is open no water flows to the plants. However, when I release via the pressure screw and allow water to come rushing out of the valve water flows to the plants.
Any ideas?
Thanks.

Wet_Boots

Supreme Member

Posts: 4,077

Location: Metro NYC

2

Saturday, May 10th 2014, 7:13am

If the replacement valve was cemented into place, there may be dried PVC cement blocking the passageway needed for the solenoid operation, and the passageway would be cleared by pushing a thin strong wire (like piano wire) through the passageway.

Rate this thread