You are not logged in.


Starting Member

Posts: 1

Location: USA


Sunday, December 16th 2001, 7:01pm

How do you install a drain valve?

I need instruction on where and how to install the 16a-fdv drain valve. <img src=icon_smile_question.gif border=0 align=middle>
Thank You

Edited by - Karen on Dec 17 2001 01:04:24 AM

Posts: 60

Location: USA


Sunday, December 16th 2001, 7:09pm


Place the drain valve in the piping after the control valve. Face the drain valve down. In other words, locate the lowest spot on the piping of a zone or section after the control valve for that section. At the lowest spot insert a tee or elbow (which ever is needed) and face the 1/2" female pipe threads of the tee or elbow in the downward position. Screw the drain valve in place (facing downward). It is always better to dig a deep hole below the drain valve and fill it with pebbles to allow the water to drain away from the drain valve. The drain valve is designed to drain the piping after the valve once the valve for that section or zone is turned off.

I hope This answers your question...if not keep on replying until we answer all your questions! <img src=icon_smile.gif border=0 align=middle>

Thanks from

Edited by - SprinklerWarehouse Irrigator on Dec 17 2001 01:10:23 AM

Edited by - SprinklerWarehouse Irrigator on Dec 18 2001 12:13:00 AM

Rate this thread