You are not logged in.

  • Login
  • Register

Hunter ICC won't automatically water higher stations

quisguous

Unregistered

1

Wednesday, May 30th 2012, 3:45pm

Hunter ICC won't automatically water higher stations

I've got a Hunter ICC-800PL with one expansion module. There are 9 zones. I can 'manually' water any station (I see stations 1-16) using the controller, I can set the watering times for stations 1-16, but when I go to set the start times, I only see stations 1-8. I've tried resetting the controller, powering off and on, removing and putting the expansion module back in.

I'm pulling out my hair, trying to figure out how to set station 9's start time.

GatorGuy

Moderator

Posts: 465

2

Wednesday, May 30th 2012, 4:07pm

Check page 36 of the manual HERE.
They mention two similar problems.
Could be a bad expansion module.

Central Irrigation

Supreme Member

Posts: 282

Location: Central Minnesota

3

Wednesday, May 30th 2012, 8:46pm

Perhaps I'm misunderstanding, but you don't need a start time for each individual zone. One start time will suffice for all 9 zones.

Wet_Boots

Supreme Member

Posts: 3,595

Location: Metro NYC

4

Thursday, May 31st 2012, 9:15am

Sounds like another instance of Operator Error, confusing Start Time 1 in Program A as a start time for zone 1, which it is not.

quisguous

Starting Member

Posts: 1

5

Thursday, June 7th 2012, 11:50am

I was confused about start times. Setting a single start time leads to all stations get watered. Not sure why I can't set a start time for the higher numbered zones, but zone 9 is getting watered just by setting a start time on zone 1 and not setting a start time for any others.

Thanks for the help!

Similar threads

Rate this thread