You are not logged in.


Starting Member


Monday, June 6th 2011, 7:10am

Toro VisionPlus II Controller

The controller shows the no power symbol and doesn't operate, power in is good, battery good, replaced fuse. Ideas?


Supreme Member

Posts: 491

Location: Seattle


Monday, June 6th 2011, 9:34pm

Do you have a multimeter. Check the transformers voltage by touching the 2 hot posts 24v inputs . If it's 4 ( 2 orange and 2 blue) just alternate them until you get proper voltage.

If you aren't getting voltage then the transformer is bad.. If you are and the controller is working then the controller is bad

Rate this thread