You are not logged in.

Search results

Search results 1-5 of 5.

Sunday, June 10th 2018, 2:35pm

Author: jruttenburg

Running two Zones simultaneously

I understand how the decoder programmer works, we have one. Page 12 does not tell me if I can give two decoders the same address. For some reason you don't seem to want to answer the question, you only want to keep telling me how much of an amateur I am. That's fine, if that's your thing. I have or have access to more test equipment than this simple system needs. I mistakenly assumed some friendly experienced person would say, yes that will work or no don't do that. I was just trying to save mys...

Monday, May 28th 2018, 10:40am

Author: jruttenburg

Running two zones simultaneously

Well earth ground is required on any CAN system that's not mobile. I have most test equipment except a decoder programmer, one on order. My question was simple. I want to run some stations simultaneously. The Hunter I-core manual only mentions running two zones in manual. If I give two zones the same address will the I-Core allow both to run at the same time?

Thursday, May 24th 2018, 9:07am

Author: jruttenburg

Running two zones simultaneously

WOW Well, I'm CAN qualified and I would bet a 400MW steam turbine is a bit more complicated than a sprinkler system and a lot more dangerous to start-up, but thanks for the advice.

Sunday, May 20th 2018, 4:35pm

Author: jruttenburg

Running two zones simultaneously

Thanks mrfixit This model uses two wires, much like CAN protocol, each station or group of stations has its own decoder that has a unique address. (my background is industrial turbine and prime mover control). I was hoping someone might have a work-around. I probably need to give each station I want to run at the sametime, the same address. Anyone know it the control will allow me to do that???

Sunday, May 20th 2018, 12:42pm

Author: jruttenburg

Running two zones simultaneously

Hi all, newby here. We are a small townhome associations (39 homes) Its very expensive to have our system maintained by Irrigation service companies. ie. a new Hunter I-Core 42 zone, we were charged $3000 installed. We have decided to tackle most if it ourselves. I have been working on it for the last few years. Retired, you know, lot of time on my hands. We have an acre and half water detention pond, we pump water from the pond to irrigate. We have two 7 1/2 hp pumps. We control with the Hunter...