You are not logged in.

Search results

Search results 1-2 of 2.

Thursday, August 9th 2018, 2:43pm

Author: DallasAggie

Greenlee 24B question

As best I could tell I followed the procedure outlined in the manual. The manual is a little poorly written. Essentially this is what I did: 1. Connected one lead to the common wire at the controller 2. Connected the other lead to the zone wire 3. switched to solenoid activate mode 4. the light indicates the solenoid is good, but the zone does not turn on

Thursday, August 9th 2018, 2:08pm

Author: DallasAggie

Greenlee 24B question

I am trying to locate my sprinkler valves, and purchased a Greenlee 24B to assist based on the chatter feature. When I use this device in solenoid activate mode, it indicates that the solenoid is good on the LED, but the sprinklers do not activate. My understanding is that this device should activate the solenoid, and if the water was on, the sprinklers would activate. Since this isn't happening, I'm concerned I won't have any luck chattering the solenoid to locate it either. Is there something ...