You are not logged in.

Search results

Search results 1-1 of 1.

Thursday, May 26th 2016, 7:53pm

Author: ranran1978

Unknown Problem

OK I am going to try and explain this the best I can: I have a zone that is like a "T" on the left side of the "T" is 3 rotors, on the right side of the "T" is 2 rotors. When I turn the zone on the 5 rotors barely come up. If I go pull two heads up by hand then all of a sudden I have pressure in all of them and they will work normal. If I cut off the right side off with left side on of the "T" and just have the left side working the three come up just fine. If I cut off the left side off with ri...