You are not logged in.

Search results

Search results 1-3 of 3.

Tuesday, July 26th 2016, 10:45pm

Author: marcob

Any comments / suggestion on this 10 year old valve setup?

These were about 4mm thick, short screws. They did a ton of work on the water system in the last couple of years, but that was a couple of miles away. In the last 7 months I had to replace 7 of the 9 diaphrams which were all messing up, that's why I was thinking about placing a filter in front to prevent stuff from clogging up my valves and my heads. The screw which I found in my main valve after one of my zones was leaking non stop. (replaced the diaphram in that zone as well)...

Tuesday, July 26th 2016, 10:03am

Author: marcob

Any comments / suggestion on this 10 year old valve setup?

This system was installed in 2005, and start to have more and more issues with it (Picture was taken during install). I believe it's time for a redo, any suggestions, comments? Couple things: Found screws INSIDE the valves so maybe time for a filter? Also, have a Rachio controller attached to it (which I love), any suggestions on flow sensors? Would like to reorganize the valves so at least they are in a straight line, absolutely no clue why they did it like this...