You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3423 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Thursday, April 7th 2005, 7:55pm

by RidgeRun05

Slip style is the way to go, faster installation and far less likely to cause problems such as leaks than the threaded valves...down the road. If you are going to use poly pipe for the lateral lines, they make valves with the barb fittings as well.

Thursday, April 7th 2005, 9:17am

by nestors

slip is easier ,if you have problems down the road you still have to cut it out .

Saturday, March 19th 2005, 4:57pm

by Wet_Boots

In a warm climate, where you don't need to 'winterize' a sprinkler system, because of freezing water, all the piping, along with the valves, would be slip style, for speed of assembly. Flow controls on 2400's are a screwdriver-adjusted type. Not as handy as a handwheel type of flow control. They aren't essential.

Monday, February 21st 2005, 9:06am

by ejzajac

irritrol valve

I'm planning on usinf irritrol 2400 control valves on the next project. Do most installers use the threaded or the slip style? Is "flow control" of value?