You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 5288 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Monday, July 26th 2004, 5:39am

by bobw

If the head doesn't even come up, it is because there is no water pressure going by it. So, based on what you've said, there are two likely scenarios.

1) The joint that you replaced was done incorrectly and is bypassing the head
2) The section of pipe between where the line was punctured and the head is plugged with dirt.

Sunday, July 25th 2004, 3:15pm

by sarora

Head doesn't pop up

While digging a hole for a tree I accidently punctured the joint which connects the sprinkler to the pipe. I replaced the joint. There are 4 sprinkler in this zone. All the other 3 sprinklers ar working fine but this particular sprinkler's head doesn't pop out.

I took out the sprikler and connected it to a garden pipe to make sure that this problem is not because of low water preseuure. Even with this the head doesn't pop out.

Can somone help me with a solution.