You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 5293 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Tuesday, July 27th 2004, 11:03am

by worleybird_m

The valves or solenoids as they are known is probably the culprit. It is probably hung open due to sand or a bad seal.
As for finding the solenoids yourself it will detail a lot of probing with a rod of some sort. It would be best to call a contractor who specializes in installing sprinkler systems. Ask beforehand if he has a wire tracer or solenoid detector.
If he does use him, if he does not he will probably look for the valves as I told you to do, and it will cost you more due to his hours involved to find them. Normally a solenoid will cost between 10 and 20 dollars less labor.
Different contractors put them in different places.
Preferably where I put them is close to the water source or the controller(timer).
Good luck

Saturday, June 5th 2004, 5:15am

by Sena

One zone stays on while others are in use

I have set a zone to 00 minutes, yet it comes on when all the others are doing their cycle.
Also, we didn't put the system in, so we don't know how to locate the valves (if this is actually the problem). Where are the valves typically located?