You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 517 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Tuesday, May 21st 2013, 11:04am

by Wet_Boots

There may be a crack in the body of the valve, which is the one thing you haven't yet replaced. Install a new valve.

Tuesday, May 21st 2013, 10:50am

by lawnboy8

Leaking Toro Valve 252

I have 5 acres in pasture and installed Toro 252 valves, 1.5" for the sprinkler lines. I have 55 psi through the system and about 12 Hunter PGP sprinklers on any given valve.


Valve 11 has presented an issue I have been unable to cure. It leaks to the sprinklers 24/7. And will run even if I crank the handle all the way down. Turning the water off to the valve does lessen the flow, but it does not stop it. I can turn the valve on and off electronically and manually. Removing solenoid power does not have any effect. I have purged and cleaned the valve five or six times now. I replaced the solenoid - no change to the leak. I replaced the diaphragm and seat - no change. I replaced the bleed valve - no change. I went through a re-tightened all the screws and replaced some screws that were a bit stripped at the head. No change. Finally, I replaced the entire top assembly - new everything. No change.

I am stuck. Any ideas on what is going on? I have a small swamp in my east field and I am not looking forward to my water bill. HELP!

Thanks

I