You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1937 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Wednesday, February 27th 2013, 7:00pm

by Wet_Boots

The absolute no-brainer fix on a Champion anti-syphon valve is achieved by replacing the entire convertor assembly that threads into the brass anti-syphon body.

Wednesday, February 27th 2013, 6:44pm

by Lester

One zone stays "on" after all scheduled watering is done

I have 3 zones in my backyard, all running on Champion anti-siphon valves. 1 of the 3 zones kept leaking water, and I didn't notice until hours later (I have it set to run really early in the morning). There are 6 sprinklers running off of that one valve - 1 of them was spraying water out at maybe 40% of what it normally does, the rest were just bubbling, and my yard was flooded. I unplugged the timer, but nothing changed, so I tightened the screw on the top of the valve to cut off the flow, and it stopped.

Can this be fixed without replacing the whole valve? Could it be the solenoid? I've never worked on valves before, so any feedback and advice will be greatly appreciated. Thanks!