You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2099 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Saturday, September 22nd 2012, 10:06pm

by Wet_Boots

You can always get electric-to-hydraulic convertors. For the pin-type valves, the Toro 284-60-00 convertors will do the trick.

Saturday, September 22nd 2012, 2:31pm

by Sartenose (Guest)

Replacement of a 40 years old failing Toro Hydraulic controller

This is a call fro help from France,
After 40 years of good service the worn out controller is definitively down; it controlled 11 Pin type Toro valves. Coming to the states on October 1st I would like to buy the equipment that is required to replace that controller, knowing that the replacement of the remote hydraulic controlled valves by electric valves cannot be done due to the landscape configuration. I thank you in advance for a very prompt reply with the references of the Toro controller and electric to hydraulic converter I will have to order.
Best regards from the French Riviera