You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 589 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The first post

Thursday, September 6th 2012, 9:01pm

by howserss

0 pressure on pump output

When the pump is sitting the pressure reads about 40PSI on the outlet side. I have a guage on it. When it turns on it goes to 0 PSI for about a minute then it finally goes up to about 50PSI while it runs. It just started doing this after I had the irrigation system installed last week. The pump never did this when I used hoses only. The pump was installed in 2008. It has never lost prime over the last 3 years and it was not used that often. Any ideas?