You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 603 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Wednesday, August 29th 2012, 6:11pm

by mrfixit

Have you reset the controller?
There might be directions on the back of the faceplate on how to do it.
Or check the manual.
This will reset the controller to the factory program.
-
Maybe that's what you meant by retrieve program memory.

Wednesday, August 29th 2012, 4:00pm

by lkt1947

Hunter Pro C Irrigation Controller all programmed but will not activate as programmed

We had a couple of power surges recently and then a power outage for about 3 hours one day. I had to re-program the Controller after each surge and it worked however, after the power outage it took reprogramming but does not run automatically. The statement that it would hold memory apparently is not true at least for my controller. ;(



I have done the Hunter quick check and saw no ERR symbols on the 11 stations. I then tried the Hunter Easy Retrieve Program Memory and neither would it save the current program or retreive the previous program.



Any suggestions will be appreciated.