You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2181 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Monday, July 2nd 2012, 8:25am

by GatorGuy

looking at a manual shows the controller to have a separate master valve connection.
I don't understand " is that because MV wire counts as 1, and #11 is 12,"

Saturday, June 30th 2012, 9:55am

by Dirtdabber (Guest)

Rain bird model ESP-12-LX Plus

Thanks, will start w electrical, appreciate your help

Saturday, June 30th 2012, 9:48am

by Wet_Boots

Electrical testing of the zone wiring is an obvious first step. If the master valve solenoid is shorted, then replace it.

Saturday, June 30th 2012, 9:40am

by Dirtdabber (Guest)

RainBird raster test result flashes "Short MV" & "Open 12"

RainBird raster test result flashes "Short MV" & "Open 12", only see valve wiring on control board up to 11, nothing in slot 12. Q1: is that because MV wire counts as 1, and #11 is 12, or what does it mean; and Q2, where would you begin troubleshooting

Bought house at 10 yrs old, believe sprinkler system was installed shortly after house was built, if that matters re age of system

Rain bird model ESP-12-LX Plus