You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 895 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Saturday, June 16th 2012, 12:29pm

by Wet_Boots

It might be that the pump relay is being seen by the controller as a short circuit.

Saturday, June 16th 2012, 11:23am

by modetz

Pump or Controller Problem

I am new to this forum. Have a large in-ground irrigation system supplied from a lake source with a pump suction system. When I started the system this spring I had a bad controller which I simply replaced with a rain bird digital model. The system checked-out fine.

Now I am randomly getting a controller error message indicating a " wiring problem" with a random zone. If a manually try to run a zone that successfuly completed the message will appear and also for any and "all" other zones. When a zone is running, I measure 24v at the controller from the common and pump start relay wires. When a zone is in the error mode those same wires measure "less than 24v". The pump start relay is less than 2 seasons old and I cleaned, checked wiring connections and manually ran the pump by depressing the switch.

If I shutoff the system and pump for an hour or so the system will restart just fine. I believe the pump is overheating at some point and when the next zone tries to start, it is drawing too much power. After the pump cools off, it starts with no problem.

Any ideas, comments or suggestions? I do not believe I have any bad solenoids as the zones open and close normally when the system is operating. Possibly the pump relay is overheating or the pump start switch is sticking, but not sure how to test. Any ideas would be much appreciated!!!! Thanks in advance... Frank