You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 681 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Wednesday, June 6th 2012, 8:06am

by GatorGuy

"hand-wired with soldered connections"
We are going back a ways, aren't we?


Should be easy to work on if nothing else.

Tuesday, June 5th 2012, 8:35pm

by Wet_Boots

I did some looking and I suspect that to get one you would have to create it yourself.
Can't find any info on those anywhere, other than on the various forums.
Nothing near what you ask for.
Good luck.
There isn't much point of having a schematic, because a Valet controller is hand-wired with soldered connections, and it all is visible. When a motor burns out, you would not be able to get your hands on a replacement for less than a hundred dollars.

Tuesday, June 5th 2012, 4:56pm

by GatorGuy

I did some looking and I suspect that to get one you would have to create it yourself.
Can't find any info on those anywhere, other than on the various forums.
Nothing near what you ask for.
Good luck.

Tuesday, June 5th 2012, 3:42pm

by Wet_Boots

If you had such a schematic, where would that get you? The company is long gone, and the most likely repair of the controller will cost you far more than a replacement controller.

Tuesday, June 5th 2012, 3:00pm

by richholm1946 (Guest)

wiring schematic for an Imperial Valet Timer

I am looking for a wiring schematic for an Imperial vale Timer unit.