You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2557 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Sunday, November 20th 2011, 7:39pm

by bigdogmedia1966

The valve I just replaced was by itself. The rest are in pairs. I guess in a way it's a good thing that they're deep because they will not freeze.

Sunday, November 20th 2011, 2:58pm

by Wet_Boots

If all the valves are in one location, you could construct new valve manifolds at a shallower depth. Assuming these are near to the house and the water supply, you would also replace the old underground upstream pipe with shallower plumbing, with the idea of not having low points where water could freeze and cause damage

Sunday, November 20th 2011, 11:57am

by bigdogmedia1966

I replaced the one Toro 250 that would not stop leaking with a Hunter PGV with flow control. I'm also going to replace the other 6 since 2 others are acting up too.

Sunday, November 20th 2011, 11:21am

by Wet_Boots

If you install quality valves, you won't have to service them for years. For deep-set valves, avoid jar-tops, and stick with conventional designs.

Sunday, November 20th 2011, 8:12am

by bigdogmedia1966

Valve depth

I'm going to replace all 7 valves and I noticed that the valves are at a depth of about 2 feet. Can I just add some elbows and raise them to a reasonable depth?