You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2432 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Friday, September 23rd 2011, 9:53am

by Wet_Boots

Measure resistances of the zone wiring.

Thursday, September 22nd 2011, 9:34pm

by Pager

finding answer to wiring problem

My rainbird esp-m sprinkler runs, I measure 28 volts at the box in the stations but no voltage is getting to the valves? In fact when I turn on station one or two or three I get 28 volts on all 6 stations. When I disconnect the wires from the terminals I get the proper voltage on the prober station. Where is the most likely place the wires are fused together? or could there be something else. One station, valve is under water most of the time or maybe lighting has fused all the wires together. I don't know where to look first.