You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2710 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Tuesday, August 16th 2011, 11:58am

by Wet_Boots

You can have two common wires connected to the common terminal of the controller.

Tuesday, August 16th 2011, 10:11am

by kharris (Guest)

wiring rainbird esp expansion module

My husband and I are trying to run sprinklers in the backyard. Our frontyard is hooked up to rainbird esp controller. We bought the expansion module for 3 more zones. My question is how do we wire it? I am not sure where the common wire goes, since the first zone is using that space and the extension only has 3 screws to use. Do we have to splice the common at the first box and run it to the second? I haven't had much luck trying to find a solution on rainbird's website for wiring an expansion module. We did get 4 multistrand wire.