You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2450 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Wednesday, August 10th 2011, 7:51am

by Wet_Boots

Pump relays are not necessarily compatible with modern sprinkler controllers, as they can draw more power than a valve solenoid. A modern pump start relay might be installed, or an "isolation relay" can go between the controller and existing pump start relay.

Tuesday, August 9th 2011, 10:59pm

by bluetractormanc

Nelson Ez pro timer troubleshooting

About a month and a half ago I noticed my sprinklers were not running. I got out my volt meter and started checking voltages, I discovered that there wasnt 24 volts coming out of timer going to pump start relay. I moved the red wire over to a open zone and opened manuel valve at the pump and turned on timer. It worked. I purchaced a new timer and the system was up and running again. Today I noticed the sprinklers were not running again, same thing timer wasnt suppling power to pump start relay. Can the pump start relay be buring out the timer circuit or is there something else wrong.