You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1064 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Sunday, May 22nd 2011, 10:55am

by Wet_Boots

Are you in a location with cold winters? There could be more cracks.

Sunday, May 22nd 2011, 9:31am

by lmeacham

Why are we still low on pressure?

I have been working on the sprinklers for two or three weeks now, the back yard looks great, but the front yard is terrible, and not getting better. We have very low pressure, and after fixing multiple problems in the line, it is better, but still much lower than it should be. Here is a list of what we have and the problems we've fixed; after each fix we checked the line and pressure is still low:

Replaced two cracked tees, both of which were causing leaks, and are no longer leaking.
Replaced a leaking coupler, which no longer leaks.
Found a spot in the line where the pipe wasn't even attached, and coupled it, no more problem. (This was probably here since the previous owner)
Replaced all the heads and risers with new ones.
Unclogged the pipe in a location where the head was not spraying; the line there is now clear.

We have 3/4" pipe, everything is correctly attached with PVC cement, the valve is open, but the water pressure is still lower than it should be. Some water sprays out of the heads, but most of it leaks down from the top of the head rather than spraying. The heads are brand new, the filters are clean. After running the sprinklers and turning them off, we saw that water was still leaking from the top of the heads (as is normal) however after unscrewing one head from its base we had a nice fountain of water for a good 30 seconds spewing from the connection point. What would the problem be? Is it a problem with the valve, is there a crack somewhere else in the pipe? Basically the question now is what would be the next thing to replace or test, considering what we have done so far and the results we have achieved?