You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1252 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 6 posts

Tuesday, May 17th 2011, 7:01pm

by Wet_Boots

One big problem with streetside taps is how you place a backflow preventer. Above-ground devices will get tripped over, or stolen for scrap.

Tuesday, May 17th 2011, 5:42pm

by lawn sprinklers

tap inside or out

There are several advantages to ouside tap, but make sure that the county allows you to tie inside the meter pit. Many counties only allow outside pit. You will gain a bit of flow and pressure, but normally not that much to make difference. As long as you tie in before any regulator on your line in basement (tie in immediately after house shut off) then you will not sacrifice and gallons or pressure. the distance form meter to house is not enouh to make difference unless you have kink in copper line or other obstructions.

Tuesday, May 17th 2011, 4:07pm

by mike_44012

Thanks

Tuesday, May 17th 2011, 11:56am

by Wet_Boots

You do get more water by bypassing the supply line to the house, when you have a meter near the street

Tuesday, May 17th 2011, 10:52am

by HooKooDooKu

To avoid water hammer as well as damage to your plumbing (including your indoor plumbing, not just the irrigation system), you don't want water to travel through pipes at a speed faster then 5 feet per second. A 3/4" copper line will reach speeds of 5fps at flows around 7GPM.
Now at my house, I have 1' PVC between the meter and the house (it transitions to 3/4" copper a few feet before the line enters the house). But even if you also have a 1" PVC line to tap into, you're still limited to about 11 GPM through the 1" line.

Monday, May 16th 2011, 10:25pm

by mike_44012

Tap outside vs inside

I have a 3/4" water meter in my front yard with a 3/4" copper line that runs into my basement. I have about 11 GPM design flow at 75 PSI but I'd like to have about 15GPM or so...

Rather than tapping the 3/4" copper in the basement, I am thinking about tapping the pipe just after the meter using 1" PVC. Would this give me more GPM or am I stuck with 11?