You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2623 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Sunday, April 17th 2011, 9:46am

by Wet_Boots

Take pressure measurements of your supply pressure. Then open one zone, and take another reading. Do this for the entire system. Compare the weak-zone reading to the others. A lower reading means you have leaks. A higher reading means you have a blocked pipe.

Sunday, April 17th 2011, 12:53am

by matt h

one zone low pressure but

I have 7 zones. Each zone has 3 heads on it. Zone #6 has low water pressure. It was so low that the sprinkler heads would not raise, just bubble over. I replaced the valve and cylinoid zone 6. I also dug up the middle head were i was sure the water line was running to first, and it was. I found a cracked connection between a elbow and the side fill for the sprinkler head, So I replaced it. Now i have better pressure,but it is still low. The heads now raise, but do not shoot very far. I did however (when I had the middle sprinkler head removed) hold my thumb over the line were the middle head should have been, and the other 2 heads rose and started working great. It was like I had enough pressure for 2 heads but not 3. After I replaced the valve I noticed that there is a really small leak at one of the connections to the valve. Very small, very minor. Will this leak affect the amount of pressure to my three heads and cause the low pressure of water? My water lines are polyurethane and very old could there be a possibility that a tree root is pinching my line which would cause the low water pressure?

Any advice/suggestions are greatly appreciated!