You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1347 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Wednesday, April 13th 2011, 10:44am

by mrfixit

The Orbit valve could be the problem. It's not a valve I would ever install unless requested by the person who hired me. Sometimes people will buy the parts and want me to install them.

As far as bleeding it without a screw you could loosen the solenoid until it leaks.

If the valve has a flow control you can try putting it in different positions.

Maybe try switching the valve to another position so it doesn't come on first or last.

What about Boots comment?

Wednesday, April 13th 2011, 8:02am

by evoqguy (Guest)

The new valve I installed is an Orbit model with no Bleed Screw. The zone performs 100% and the water pressure seems right as well and no different then from any other zone. The issue is only when it switches on (Its the first valve of the 6 Zones I have) and it occurs again when then zone is slowly closing. It seems to be a pretty violent shake and thats why I am concerned it may damage the system or pipes connected to it. I was thinking maybe the valve itself is no good. Is there any way to remove the air besides a bleeder screw or should I try blowing out the entire system and restarting?

Tuesday, April 12th 2011, 12:36pm

by mrfixit

Did you release the air by opening up the bleeder screw? Could still be some trapped in there.

Tuesday, April 12th 2011, 12:21pm

by Wet_Boots

How does the zone this valve feeds compare to the others? Sometimes these noises indicate an excess flow.

Tuesday, April 12th 2011, 10:49am

by evoqguy (Guest)

New Valve Vibration

I just switched out my old Irritol 2400T valve with a new one. Now when you turn on that zone is comes on vibrating and makes alot of noise. It will then quiet down but once it shuts off the whole thing vibrates and shakes again. I have tried turning on all the zones to release any air. Any suggestions on whats wrong or what I can do to correct this issue? Is this a bad valve?