You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1533 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Friday, August 13th 2010, 11:51pm

by HooKooDooKu

Determining actual GPM is a bit of an itterative process because to get accurate information, you have to estimate what your working pressure at the spray head is going to be, then use charts for the spray head to determine GPM. Add up all the GPMs running through all the pipes, determine pressure losses in the pipes. Use the pressure losses to determine working pressure. Use working pressure to estimate GPM at each spray head. Use GPM of each spray head to determine GPM through each pipe, use GPM through each pipe to determine pressure losses in each pipe, use pressure losses to estimate working pressure at each spray head...

Friday, August 13th 2010, 1:19pm

by WLC (Guest)

Need help calculating my GPM

Hi all,

I am designing my first sprinkler system and need help calculating my GPM.

Water Meter: 5/8 in
Service Line from WM: 1 in

We have a spigot next to our water on/off lever in the basement and I put a pressure gauge on it and got a reading of about 80 PSI.

The city said to plan/design to 42 PSI.

What should I plan on for a working pressure and for my GPM? I'm getting different answers from different sources/charts.

THANK YOU!!!