You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1503 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 6 posts

Sunday, July 18th 2010, 11:35pm

by Fireguy97

It sounds like you also have a master valve

Mick

Sunday, July 18th 2010, 10:32am

by kingtpt

Thanks I did that but i found out that the manual switch wouldn't work until i turned it on automatically . it now works fine

thanks for the help

Saturday, July 17th 2010, 7:58pm

by mrfixit

I always open a bleeder screw or the solenoid when I turn the water back on after installing or repairing a valve. You'll want to get the air out of the valve using the bleeder screw at some point.

Saturday, July 17th 2010, 6:44pm

by kingtpt

after putting in new diaphragm do you have to wait for the system to pressurize up or should it work right away

Saturday, July 17th 2010, 6:16pm

by mrfixit

If you're turning on the valve manually at the valve itself then the problem is the diaphragm. I'd change the diaphragm or change the valve depending on the model valve.

Saturday, July 17th 2010, 5:57pm

by kingtpt

one zone low pressure

I have one zone that gets low pressure when i use the automatic start but it i manally start the zone it works fine. what could be the problem?