You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3090 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Monday, June 28th 2010, 3:42am

by mrfixit

I wont be able to help you with this valve.

Sunday, June 27th 2010, 11:31pm

by andrewandheather

not sure what you mean by controller. It's the valve I replaced Orbit model 91035. Instead of having two wires from the valve to connect to my timer, it had an male jack, when cut there were 3 wires.

Sunday, June 27th 2010, 6:10pm

by mrfixit

Do you mean you've replaced the controller?

Sunday, June 27th 2010, 4:20pm

by andrewandheather

Relacing old valve (2 wire) with new valve that has 3

I am replacing one of my old Orbit valve with a newer model that has 3 wires. On the advise of a home depot guy, I cut the connector off the new valve and wired 2 of the 3 braided wires to my existing wiring system. I left the green wire dangling. This of course blew the fuse. Does anyone know if this can be done and how?