You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1873 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Monday, July 13th 2009, 10:02am

by worachj





Per the manual you are doing a "Normally Close Installation". The short blue wire should be labeled "Normally Open" and is not used for your type of installation. Ignor the blue wire. The red and black wire should connect directly to your controller.

Sunday, July 12th 2009, 5:28pm

by lewhollish

I have both manuals, and they both show two wires. I have three. Controller says "connect both rain sensor delay wires to the terminals marked rain sensor". I have three. I need to know which ones to use or do two go together.

Sunday, July 12th 2009, 4:06pm

by Wet_Boots


Sunday, July 12th 2009, 2:08pm

by lewhollish

rainbird sensor hookup

I have a rainbird stpi-900 with a rainbird rsd-bex sensor. The controller has two spots for wire hookup but the sensor has three. A black, blue and red. Which goes where? Thanks for any help.