You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1928 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Friday, July 10th 2009, 2:31pm

by mrfixit

I'll give this a stab. It sounds like the controller to me. The fact that the problem stops the moment you disconnect the wire tells me the controller is probably sending some sort of signal to the valve. Are there spider webs inside the controller? Sometimes those can cross circuits. Sometimes controllers just go bad.

You could try moving the number 8 wire an empty spot. Like number 15.

Thursday, July 9th 2009, 10:29pm

by wingnut (Guest)

The unusual and unintentional

I'm having an annoying problem. I have a Rain Bird ESP 16LX+ controller (2001 date code), zones 1-12 installed mid '90s by previous owner and zones 13-14 installed in '03. A few weeks ago zone 13 began running when the controller was set to off. At first it was as if the valve was partially open and the pipes inside and outside the home were vibrating. Closing the main water valve stopped the water but wouldn't correct the problem when turned back on. So I pulled the wire inside the controller from that zone and it stopped the water flow. I replaced the solonoid and all seemed normal again. Fast forward a few weeks... Zone 4 comes partially on without being turned on. Heads come up and down while the pipes vibrate again. During this time zone 8 is periodically vibrating and one head is leaking water and zone 13 also comes on (the one that I just replaced the solonoid a few weeks earlier). After several minutes of watching this madness, zone 8 remains vibrating and leaking water so I pull that wire from the controller and it stops. I didn't remove any other wires. After 20-30 mins I manually went through several zones, including those that came on by themselves (with zone 8 disconnected) and didn't have any problems. What is going on? Is the controller causing this?