You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 1865 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Friday, June 12th 2009, 10:38pm

by Wet_Boots

You'd be a lot better off getting one-inch poly pipe, and eliminating the possibility of pressure-loss problems.

Friday, June 12th 2009, 3:02pm

by bbhmj

Pressure Question

To hijack the thread ........

I am in the process of installing a new system using 1/2" poly pipe. I am using two zones, one using Rainbird 1804, the other using 5000 rotors. Both zones are small, using 4-5 heads in each. When I ordered the rotors, I didn't notice they were 3/4" ends.

In retrospect, I should have ordered 3/4" line, but if possible I would like to avoid returning / ordering new poly pipe. Can I keep the rotors and just use an adapter for the difference in size? How will it affect the pressure?

Wednesday, June 10th 2009, 8:43pm

by hi.todd

or get the fitting that can go from 1/2 to 3/4"

Good Luck :thumbsup: :thumbup:

Wednesday, June 10th 2009, 6:26pm

by Wet_Boots

Look harder, they're there.

Wednesday, June 10th 2009, 2:17pm

by tbtim

RainBird Sprinklers with 3/4" botton

I was trying to order some spray sprinkler bodies for my Rain Bird system but I can only find with 1/2" bottom and I need 3/4"