You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3982 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 2 posts

Wednesday, July 30th 2008, 8:59pm

by hi.todd

It sounds like a pressure problem at the head. there maybe a hunk of dirt that got in to the sprinkler head while you were replacing the head. You should take off the rotor look into the bottom of it wash it off and clean it as best you can. turn on the zone let the water gush out of the open hole for a few seconds. When you get back to the hole try not to let dirt get into the system and put the head back on. If the water does not have pressure coming out of the hole in a strong way then you may have dirt clogging the system at a funny pipe 90 or fitting.
Good Luck :thumbsup:

If you are still having problems after this point you may need to replace the head with a Hunter PGP or Rainbird 5000. Dan

Tuesday, July 29th 2008, 4:25pm

by SSoens (Guest)

Sprinkler head not rotating

I have Nelson 6000 heads. One particular head was not rotating. I replaced it with a brand new head, but the water stream still will not rotate. Where can I go for troubleshooting help?