You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 3698 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Saturday, May 3rd 2008, 4:37am

by drpete

I agree about the pressure siuation. First tell me why you only have 4.5 gpm? What is your mainline into your house. Are you using a hose bib?

Thursday, May 1st 2008, 7:21am

by Wet_Boots

Use smaller nozzles - you don't have anywhere near enough pressure at the heads.

Wednesday, April 30th 2008, 8:13pm

by Graebeard (Guest)

RB 5000 - no Rain Curtain

Hi folks,

I'm trying to install a RainBird system but seem to have configuration problems. First off, I have 45 psi and about 4.5 gpm. I connected one rotor with a #1 nozzle and tested. It shot a 30 ft stream, but no discernible curtain. I then added another RB but with a #6 nozzle. This one wouldn't even pop up until I manually pulled it up. Then both rotors dropped to about 5 or 6 ft radius. Still no curtain, and both heads also sprayed through the rubberized top - thru the screw holes.

Is there some other adjustment I need to make that is not documented anywhere? These are not the Plus heads, just the simple RB5000

Any assistance would be greatly appreciated.