You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2536 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Sunday, October 7th 2007, 6:49pm

by edwildesr

There are 5 tramsformers around my house for low voltage lighting. A really simple control setup is to plug each into a Black and Decker X-10 outdoor remote switch. The X-10 system reacts to commands that are sent over the house wiring from all types of X-10 controllers and switches that are plugin or wireless, CHEAP and can be anywhere in the house including on your computer. This gives you even bedside control of outdoor lighting (if you want it for security checks). There are lots of other options including replacing the outdoor receptacle with an X-10 receptacle for about $12. The beauty of this system is that you don't have to reset timers in case of a power failure or DST change. The computer interface also adjusts for incremental dawn/dusk time changes yearround on a daily basis. Be sure to pull the time pegs on the transformers and leave them in the ON state. Checkout sites like www.x10.com or smarthome.com. You can probably do 3 transformers for $100 total including the $50 computer interface in about 30 minutes.

Friday, September 21st 2007, 9:19pm

by Bill Painter

As Josh said, you can do it, but it can be a bit complex. If you're familiar with electronics, you can drive 24/lighting input voltage relays to run each lighting transformer in any give area. I've done about a half dozen systems and have had good results. Lighting can be made to turn on and off at each "station" at designated times, just as with sprinkler zones.

Friday, September 14th 2007, 1:39pm

by jmduke7

Yes you can, but it really is no benefit to you to do so. You will still need to get a low voltage transformer for the lights, and most of those have a modular type connection for a timer or photocell. Since the both are reasonably priced (photocell & timer) its a better idea to use them instead. A photo cell can't be used with the Hunter ICC / Hunter Pro-c controller without heavy and complex wiring, so that will limit the functionality of the low voltage lighting system.

Friday, September 14th 2007, 5:52am

by ArrakeenIrrigator

Using a sprinkler controller to control lighting

I've heard some casual comments about how a I could use my sprinkler controller, a Hunter Pro-C, to manage a schedule for my low-voltage lighting. Can someone advise me on if this is true and if so, how I can get my controller to control my transformer?

Thanks.