You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2534 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 5 posts

Monday, September 24th 2007, 1:04pm

by aquatechirrigation

Be careful with this elevation change. By the time you get to the top of the hundred feet you will lose 44psi. The formula is .44psi/Ft of elevation change. We have incountered this problem before and you either install the rpz, 2 backflows or a non dumping backflow(not code in new england!).

Saturday, August 11th 2007, 11:37am

by Wet_Boots

Plan B is to replumb the uphill stuff so the antisyphon valves are at the top of the property, or wherever they can have the needed elevation difference. Lots more work, but no RPZ losses.

Saturday, August 11th 2007, 9:01am

by TimCA

I am on a well so the presure is between 30 and 50 as it cycles on and off. I am running roters (Orbit and hunter). I would guess that 10 to 15 lbs of friction losss that is not an option..... howmuch back presute and a 3/4 valve with back flow handle?
TimCA

Friday, August 10th 2007, 12:56am

by Wet_Boots

Hard to tell without seeing the site in person. If you are lucky enough to have lots of pressure, then another backflow preventer can easily be cut into the supply. Where you live figures into your choices. The one device to fit any situation is the RPZ, and you lose at least 10 to 15 psi when it's installed.

Thursday, August 9th 2007, 8:38am

by TimCA

Help with valves in system....and hills

Good afternoon,

I live on 2 acres, the lot is about 600 x 300. The height from front to back (elevation change) is about 100 ft. When I bought the house the irrigation system was in. Most of the valves ate at the house , about half way up the hill. Most of the rotors and drip are above the house. I just read that the Antisiphon valves that are installed “must be installed” 6” higher than the highest sprinkler. This is not the case….. The highest sprinkler is about 20 ft above the valve. What should I do????

Thanks
Tim