You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4282 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Sunday, July 29th 2007, 7:25am

by Jan

So since my rotor 300 series head is set to 180 degrees, that is where it stays unless I change an internal part....but I can reposition the coverage area by turning the entire head. Thanks, I will try this.

Sunday, July 29th 2007, 4:10am

by Wet_Boots

If the coverage pattern is out of position, turn the entire head. The 300 series do not adjust. You change an internal part to obtain a different arc of coverage.

Saturday, July 28th 2007, 4:27pm

by Jan

how do I adjust my Toro rotor 300-03 head

I have older sprinkler lines and heads. How do I adjust my Toro rotor 300-03 sprinkler head? It should be at 180 degrees, and I need it turned so as to sprinkle the correct area. How do I do these things? I sure would appreciate anyone's help/advice.