You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2446 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Sunday, August 5th 2007, 12:25pm

by mrfixit

http://www.sprinklertalk.com/forum/topic.asp?TOPIC_ID=2323

Sunday, August 5th 2007, 10:41am

by AGi

<b>For all those looking for answers.....</b>
If your having problems with a module, try resetting the controller. The instructions are in the manual.
I did this and it solved my problem. Of course I had to reprogram the controller, but after doing so, the module worked fine.

Monday, July 23rd 2007, 9:59am

by AGi

Troubleshooting PCM300 Module

Posted - Jul 23 2007 : 1:42:47 PM
--------------------------------------------------------------------------------

I recently repaired a light commercial system. Supply line had burst in four places (improper shut down last year). After the line repair, I activated the controller - Hunter Pro Series 300i - and zones 1,2 and 3 worked fine. Zones 4,5 and 6 which are hooked up to an PCM300 expansion module did not come on. I disconnected the zone 3 wire and one at a time, I hooked up zones 4,5 and 6. Each of the non operating zones worked when attached to zone 3. This leads me to believe that there is no problem with the wiring or the valves for zones 4,5 and 6. I believe that the expansion module needs replacement. Is there anything else I can do to prove this, before replacing the expansion module.