You are not logged in.


Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 4006 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Friday, June 29th 2007, 3:16pm

by Wet_Boots

If the existing heads use the side inlets, you could just cut the inlet pipe and make a new connection to the PGP. Use the swing pipe and fittings to make up the difference in height.

Thursday, June 28th 2007, 11:00am

by SpriniklerGuy

Actually, I just looked at the swing pipe on Web site and see that it has fittings that can do the reduction from 3/4" to 1/2" so if I use it I shouldn't need the bushings, right?

Thursday, June 28th 2007, 10:51am

by SpriniklerGuy

Replacing RainBird MaxiPaw with Hunter PGP

I have about 20 Maxi Paws with which I'm completely fed up (cleaning out debris, etc.) I've decided to replace them with Hunter PGP-ADJ rotors given all of the good things I've read about them. I've replaced a few so far and all of them were connected to the side (1/2") inlet. The Hunter PGP only has a 3/4" inlet on the bottom. If I use a reducer bushing (3/4" male to 1/2" female), I think I should be able to connect the PGPs. However, I have some questions:

1. Will the reducer change the performance characteristics of the PGPs?
2. Am I better off using the PGP-ATR (I've read responses on the forum that seem to favor the PGP-ADJ as opposed to the ATR)?
3. Assuming there are no swing joints (and I don't think there are), are they the best way to get the connection lower so the head doesn't stick out of the ground (i.e., the height will be different for the PGPs because it connects from the bottom)?

Thanks for your help..