You are not logged in.

Reply

Dear visitor, welcome to SPRINKLER TALK FORUM - You Got Questions, We've Got Answers. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Attention: The last reply to this post was 2645 days ago. The thread may already be out of date. Please consider creating a new thread.

Message information
Message
Settings
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 3 posts

Sunday, June 3rd 2007, 5:23pm

by gregory1420

i would suggest more filters then..

Sunday, June 3rd 2007, 12:20pm

by Wet_Boots

Can you filter the water any more? I've seen even 100 mesh filtering not remove the silt that could affect gear drive operation. Think of it. Gear drive sprinklers have a small stainless steel 'impeller shaft' spinning in a plastic sleeve. All very light-weight, and not difficult to jam. They'd really be happier with city water.

For silty water, the old standby remains the impact head. Clunky and primitive. Indifferent to water supply.

Thursday, May 31st 2007, 7:00am

by ovalwindr

best replacements

Our house is on 2.6 acres of which most is lawn. This system is one that I designed. Our water comes from a canal through 6" pipe 430 feet away to a sump at the corner of our property. The pump is a cornell 5hp, 140 gmp and a average of 60 to 80 psi pending on which station. It is filtered thru a clemons m80, a clemons sand trap, and finally a fine screen 50 mesh filter, all of which are on timers before the system starts up. We have 12 station, 8 which are 5000 plus (66), 1 which was 25 2500 rainbirds, they didn't even make it past there warranty before they were replaced with mp rotators, and the other 3 stations (42) are mp rotators. The 2500 would just get to where they would quit, and now the 5000 are starting to fail to. The filter in the bottom of the rotors is clean, but they have just started to quit turning, go out and turn it and some will come back to life and some don't, This system was installed in 2004 with everything from sprinkler warehouse. So what is going to be a better rotor to out last the rainbird? The canal we pump out of is silty, but with all filtering, why would they start failing? Jeff Robins.